Splint Shell

You are here:
< Back

[learn_more caption=”Prerequisites” state=”open”]

D3Splint Version: v0.3.9 and later

Minimum Pre-Requisite Functions:  Trim Model

Recommended: No additional recommended pre-requisites


[learn_more caption=”Basic Use” state=”open”]

Splint shell will add an even offset shell.  It will extend into the Splint Model.   Do not worry, this will be removed in the Finalization steps.  Press Splint Shell, choose the desired thickness.  When the operator is finished, the Splint Shell will be displayed.  Immediately afterward, the thickness can be changed in the lower lefthand panel.  If other obejcts need to be unhidden to evaluate the thickness, unhide them, and then re-run the operator by pressing the button again.  The shell will be the basic structure on which other elements are added to to build the final posthesis.




[learn_more caption=”Advanced Use/Information”]

There are no advanced or alternate uses for Splint Shell


[learn_more caption=”Known Issues”]

There are no known issues with Splint Shell